vintage Yamaha amp + Yamaha turntable + Mission Cyrus speakers

vintage Yamaha amp + Yamaha turntable + Mission Cyrus speakers Introduction

Matched Yamaha amplifier and turntable with Mission Cyrus speakers for sale - rosewood finish on all components - the components are in excellent condition and work well - the camera flash may cause the finish to appear lighter than it actually is, especially on the amp - sold as is - $875 for everything together. Yamaha CA-44 amplifier - black face plate with rosewood finish wood cover - 25Wpc into 8 ohms - inputs: phono; tuner; and 2 tape loops - full range power output meters - headphone jack - speaker load impedance: 4 ohms to 16 ohms - made in Japan - see following for full specs and link to owner’s manual: https://www.hifiengine.com/manual_library/yamaha/ca-44.shtml Yamaha YP-66 turntable - semi-automatic belt drive turntable - rosewood vinyl wrapped plinth with lightly smoked dustcover - new belt - 45 RPM adapter included - anti-skate counterweight included - Shure M55E cartridge with new Shure stylus - recently cleaned and lubricated - made in Japan Mission Cyrus 782 speakers - please note: these are the Mission Cyrus 782 speakers and not the similarly named Mission 782 speakers - the latter are floor-standing speakers - 2-way, stand-mounted loudspeakers - drivers: two 7" polypropylene-cone woofers and a 1" ferrofluid-cooled, fabric-dome tweeter. - frequency response: 75Hz–20kHz ±1.5dB (–6dB point: 49Hz) - impedance: 4 ohms - sensitivity: 91.5dB, measured at 1m/2.83V - crossover frequency: 3.2kHz - recommended amplifier power: 25–150Wpc - each speaker measures 10" W by 20" H by 13" D (with grilles in place) and weighs approximately 30 pounds - two pairs of five-way binding posts to support bi-amp/bi-wire connections (one binding post on one speaker is missing - has no impact on performance as bridge is soldered in place - post could be replaced if buyer wishes to bi-amp/bi-wire speakers) - original speaker grilles with badges included - one grille has a few pulls in the fabric and tip of one mounting post is missing - base of same post holds grille in place - made in England - identical serial numbers - one of many online articles about the Mission Cyrus 782: https://www.stereophile.com/content/mission-cyrus-782-loudspeaker speaker stands - model SPS60 - height adjusts from 11” to 13” - 8.125” square metal top plate - steel construction - originally retailed for about $80 with tax in the mid-1980s More photos available upon request. See my other ads for many interesting items, including hundreds of LPs and CDs. If you are reading this ad, then the system is available. Please do not write and ask whether it is available - and that includes sending one of kijiji's time-wasting default messages - because that question has just been answered. No texting.