AFM Lathe TUG 40X2000

AFM Lathe TUG 40X2000 Introduction

Tug-40 Engine Lathe Distance between centers: 2000 mm Center height: 217.5 mm maximum diameter of the rolling rails of the bed: 400 mm maximum diameter of turning over slide 240 mm maximum diameter of the rolling chosen. bridge: 640 mm turning length in selected. 156 mm torque on the spindle (at full power): 735.5 Nm 75 kGm maximum chip cross section (without copying device: 3.5 mm2 number of speed stages Spindle speed: 14 Spindle speed range: 16-1400 rpm – Speed variation: 1.41 spindle diameter: 52 mm number of longitudinal feeds: 42 longitudinal feed range: 0.045-3.36 mm / rev. number of transverse feeds: 42 range of transverse feeds: 0,0225-1,68 number of longitudinal feeds: 42 range of fine feeds: 0,018-1,344 mm / rev. number of metric thread jumps: 32 metric thread jumping range: 0.75-28 mm number of fine thread metric threads: 10 thread jumping range.. : 0.3-0.9 mm number of inch thread jacks: 35 inch thread pitch: 28-3 / 4 in. the number of inch threads.. : 19 thread pitch range. : 70-7 1/2 w / cal. number of threaded modular threads: 28 range of threaded modular threads: 0,375-14 II mm number of threaded DP threads: 35 DP threading range: 56-1 1/2 II zw / cal. Length of bridging: 312 mm Taper seat: Morse No. 5 Traveling of the tailstock: 180 mm Travel of the tailstock: 15 mm Screw travel (metric): 6 mm Power of the motor: 5.5 kW rated speed: 1450 rpm. 50 Hz electropump motor power: 0.125 kW rated revolutions: 2800 rpm 50 Hz Price includes loading on truck Milton,ON