5 GALLON Bloomfield Hot Water Dispenser 208V Used like BUNN

5 GALLON Bloomfield Hot Water Dispenser 208V Used like BUNN Introduction

MODEL: 4C-1225-5G-208V Bloomfield Ind. 1225-5G-208V 5 Gallon 208V Hot Water Dispenser. 4000V 7” wide Front to Back: 14 1/4" Height: 27 1/4" Used excellent/good condition. Own at a discount compared to new. Internal tank recently maintained/delimed/descaled, flushed with water. Will require WS-85218 Inlet Valve Fitting Kit or equivalent appropriate one ~$15 https://www.bloomfieldworldwide.com/wp-content/uploads/Owners-Manual-1222-1225-1226_compressed-min.pdf Please see photos for actual item for sale. Pickup at Major Mackenzie and Markham rd. Details With this Bloomfield 1225-5G automatic hot water dispenser, it's easier than ever to keep hot water readily available for hot chocolate, tea, and all your food preparation needs! This model features a 5 gallon holding tank that lets it dispense up to 18 gallons of water per hour, and the easily adjustable thermostat comes factory set at 199 degrees Fahrenheit. Thanks to its compact 7" wide design, this dispenser takes up minimal kitchen space, too! - Space saving, 7" wide design - Ready-to-dispense light lets you know when the water is at the proper temperature - Water tank with drain system for easy cleaning - Adjustable thermostat, pre-set to 199 degrees Fahrenheit - Rear panel heat switch de-energizes tank heating element for initial fill - Single-panel design allows easy maintenance - 208V, 4000W Overall Dimensions: Left to Right: 7" Front to Back: 14 1/4" Height: 27 1/4" A. START-UP For initial start-up, or if the dispenser has not been used for an extended period of time: ☑ Be sure the water supply is properly connected and the water supply valve is turned ON. ☑ Be sure the WATER TANK IS FILLED. IMPORTANT: Fill the water tank before energizing tank heater: 1. Be sure TANK HEATER SWITCH is "OFF", then plug unit into an appropriate receptacle. "POWER” light will glow any time unit is connected to electric power. 2. The fill solenoid will open and water tank will begin filling. 3. When the fill solenoid shuts off, open the faucet. Run water until the fill solenoid is energized again, then close the faucet. This will purge all air from the system. When fill solenoid shuts off, tank is filled. 4. Press tank heater switch to "ON". Tank heaters will energize. When the "HOT WATER READY" light glows, water is ready to use. A. USE 1. Always use a container suitable for hot water. 2. Hold container under faucet. Pull faucet handle to dispense hot water. Release handle to stop dispensing.